LEWPLC

OMRON H7CX-A4S-N 100-240 VAC

฿0.00

จำนวน

เหลือ 0 ชิ้น

หมวดหมู่ : siri
รหัสสินค้า : 085344

รายละเอียดสินค้า OMRON H7CX-A4S-N 100-240 VAC

Function	1 Stage Preset Counter,Total Preset Counter
Preset stages	1 stage
Rated supply voltage	100 to 240 VAC 50/60 Hz
Operating voltage range	85% to 110% of rated supply voltage
Power consumption	Approx. 9.4 VA (at 264 VAC)
External power supply	12 VDC(+-10%) 100 mA
Counter (Count range)	-999 to 9999
Counter (Max. counting speed)	30 Hz/5 kHz(switching) Minimum counting input signal width: 16.7 ms(ON/OFF ratio: 1:1)/0.1 ms(ON/OFF ratio: 1:1) Common setting for CP1 and CP2
Counter (Input mode)	Increment decrement or increment/decrement (UP/DOWN A (command input), UP/DOWN B (individual input) and UP/DOWN C(quadrature input))
Counter (Output modes)	N, F, C, R, K-1, P, Q, A, K-2, D, L
Counter (One-shot time)	0.01 to 99.99 s variable
Counter (Reset system)	External, manual and automatic reset (internal according to C,R,P and Q mode operation)
Input signal	CP1 ,CP2 ,Reset ,Total reset
Input method	No-voltage/Voltage input(selectable)
No-voltage input (No-contact input)	Short-circuit (ON) impedance: 1 kOhm max. Leakage current(0 ohm): Approx. 12 mA Residual voltage: 3 V max. Open circuit impedance: 100 kOhm min. Maximum voltage: 30 VDC max.
No-voltage input (Contact input)	Use a contact which can adequately switch 5 mA at 10 V.
Voltage input	Hight level: 4.5 to 30 VDC Low level: 0 to 2 VDC Input resistance: Approx. 4.7 kOhm
Applicable two-wire sensor	leakage current: 1.5 mA max. Switching capacity: 5 mA min. Residual voltage: 3.0 VDC max. Operating voltage: 10 VDC
Minimum input signal width	External reset: 1 ms/20 ms(selectable)
Standby time	290 ms Max.
Control output (Contact output)	Output type: SPDT Switching capacity: 3 A at 250 VAC/30 VDC, resistive load (cos phi=1) Minimum applicable load: 10 mA at 5 VDC (failure level:P reference value)
Display method	7-segment negative transmissive LCD
Digit	4 digit
Character height	Count value: 12 mm (Red, green or orange programmable) Zero suppression: Equipped Set value: 6 mm (Green)
Prescaling function	Provided (0.001 to 9.999)
Decimal point adjustment	Rightmost 3 digits
Key protection	Key protect Switch
Teaching function	Not provided
Batch counting function	Not provided
Communications	Not provided
Memory backup	EEPROM (Number of rewite: 100000 times min., Service life: Approx. 10 years min.)
Surrounding air temperature	Operating: -10 to +55 CEL (Counters are mounted side by side: -10 to 50 CEL (with no icing or condensation)) Storage: -25 to +70 CEL (With no icing or condensation)
Ambient humidity	Operating: 25% to 85% Storage: 25% to 85%

Insulation resistance	100 MOhm min. (at 500 VDC) Between current-carrying terminals and exposed non-current-carrying metal parts / Between non-continuous contacts
Dielectric withstand voltage	Between current-carrying metal parts and non-current-carrying metal parts: 2000 VAC 50/60 Hz for 1 min Between power terminals and control input terminals: 2000 VAC 50/60 Hz for 1 min Between control output,power supply, and input circuit: 2000 VAC 50/60 Hz for 1 min Between non-continuous contacts: 1000 VAC 50/60 Hz for 1 min
Impulse withstand voltage	Between power terminals: 3.0 kV Between current-carrying terminal and exposed non-current -carrying metal parts: 4.5 kV
Noise immunity	Between power terminals: +-1.5k V Between input terminals: +-600 V Square-wave noise by noise simulator (Pulse width: 100 ns/1 us, 1-ns rise)
Static immunity	8 kV (malfunction), 15 kV (destruction)
Vibration resistance (Destruction)	10 to 55 Hz with 0.75 mm single amplitude for two hours each in three directions
Vibration resistance (Malfunction)	10 to 55 Hz with 0.35 mm single amplitude for ten minutes each in three directions
Shock resistance (Destruction)	300 m/s2 three times each in six directions
Shock resistance (Malfunction)	100 m/s2 three times each in six directions
Mechanical Life expectancy	10,000,000 operations min.
Electrical Life expectancy	100,000 operations min. (3 A at 250 VAC, resistive load)
Degree of protection	Case front: IEC IP66, UL508 Type 4X (indoors) (when using the Y92S-29 Waterproof Packing) Case rear: IP40 Terminal block: IP20
Applicable standard (UL)	Standard No.: UL508 File number: E41515
Applicable standard (CSA)	Standard No.: CSA C22.2 No.14 File number: LR22310
Applicable standard (VDE)	VDE0106/P100
Applicable standard (EC Directive (Machinery Directive))	EN61010-1
Applicable standard (EC Directive (Low Voltage Directive))	EN61010-1
Applicable standard (EC Directive (EMC Directive))	EMI: EN61326 Emission Enclosure: EN55011 Group 1 Class A Emission AC mains: EN55011 Group 1 Class A EMS: EN61326 Immunity ESD: EN61000-4-2 (4 kV contact discharge (level 2);8 kV air discharge (level 3)) Radiated electromagnetic field immunity: EN61000-4-3 (10 V/m (Amplitude-modulated, 80 MHz to 1 GHz) (level 3);10 V/m (Pulse-modulated, 900 MHz +-5 MHz) (level 3)) Immunity Conducted Disturbance: EN61000-4-6 (10 V (0.15 to 80 MHz) (level 3)) Immunity Burst: EN61000-4-4 (2 kV power-line (level 3);1 kV I/O signal-line (level 4)) Immunity Surge: EN61000-4-5 (1 kV line to lines (power and output lines) (level 2);2 kV line to ground (power and output lines) (level 3)) Immunity Voltage Dip - Interruption: EN61000-4-11 (0.5 cycle, 100% (rated voltage))
Mounting method	Flush mounting
External connection method	Screw terminals
Case color	Black (Munsell N1.5)
Attachment	Flush mounting adapter, Waterproof rubber packing, Shock Prevention Cover
Weight	Approx. 130 g