LEWPLC

GT2-75N KEYENCE ราคา 5,000 บาท

฿5000.00

จำนวน

เหลือ 0 ชิ้น

ซื้อเลย

หยิบลงตะกร้า

หมวดหมู่ : Stock Project 2
รหัสสินค้า : 003160

รายละเอียดสินค้า GT2-75N KEYENCE ราคา 5,000 บาท

Model		GT2-75N
Mounting method		Panel mount
Type		—
Main unit/Expansion unit ^*1		Main unit
Power supply voltage ^*1		10 to 30 VDC, including 10% ripple (P-P)
Power consumption	Normal	2200 mW max. (30 V, 73.3 mA max.)
	Power saving (Eco)	1700 mW max. (30 V, 56.7 mA max.)
Display power	Measured value display	6 + 1/2-digit 7-segment LED (red)
	Other displays	2-color, 13-level bar LED display (red, green), indicators (red, green)
Display range		-199.999.9 to 199.999.9
Display resolution		0.1 μm 0.004 Mil
Sampling rate		1000 times/sec.
Control input	Timing input	Input time: 2 ms min.
	Preset input	Input time: 20 ms min.
	Reset input
	Bank input
Control output	HH	NPNopen collector, Applicable current: 50 mA,Maximum applicable voltage40 V Residual voltage at ON: 1 V max. * N.O./N.C switchable
	High
	Go
	Low
	LL
Analog output		—
Response time		hsp (3 ms), 5 ms, 10 ms, 100 ms, 500 ms, 1 s
Environmental resistance	Ambient temperature	-10 to +50°C (14 to 122°F) (No freezing)
	Relative humidity	35 to 85% RH (No condensation)
	Vibration	10 to 55 Hz, 1.5 mm 0.06", double amplitude, 2 hours in each of X, Y, and Z directions
Materials		Main body case: Polycarbonate, Key top: Polyacetal, Front sheet: PET, Cable: PVC
Power supply/I/O cable		12-core connector connection (Connecting cable included)
Weight		Approx. 140 g (including panel mounting bracket, protective front cover and power cable)
Accessories		Panel mounting bracket, protective front cover, power cable, instruction manual, cover seal
^*1 Precautions when the GT2-70 Series is used with an expansion unit (excluding GT2-71D) Up to 15 amplifier units can be connected; main unit: 1 unit, expansion unit: 14 units. To use the DIN-rail mount type, be sure to mount the amplifier unit to a DIN-rail (using the metal bracket). When mounting additional units, be sure to use the end units (OP-26751). When mounting additional units, depending on the number of units to be added, confirm the following specification limitations. ［Up to 8 units (including main unit)］The power supply voltage is 20 to 30 VDC.The maximum applicable current for each output is 20 mA. ［Up to 9 to 15 units (including main unit)］The power supply voltage is 20 to 30 VDC.The maximum applicable current for each output is 10 mA (including DL-RB1A output current).The residual voltage at ON Is 1.5 V or less.