2L3.5/36LH 36 pole spring-clamp connector (Weidmuller) Wire size: 0.3mm to 1.0mm (AWG#18 to AWG#22)
* The terminals for DIO power supply are located on the analog input/output connector.
When LT Series is powered up and the system is booted, the relay of the alarm output circuit turns ON. When a major error or watchdog error occurs, this relay switch turns OFF. An external fail-safe circuit can be provided to monitor this relay output.
Note: This relay switch is OFF from the time the power is turned on until the LT Series system is booted. The external monitoring circuit must be started after the LT Seires system is booted.
Important: Use twisted and shielded 2-conductor cable for analog input wiring, and do not route it near high-voltage, high-current, high-frequency cables (such as those for inverters) or power cables. Also, do not bundle it with any of these cables; place them in separate wiring ducts.
Note: Panel thickness should be between 1.6 and 5.0 mm (0.06 to 0.02 in.), and should be based on the strength required to mount the LT to the panel.
ระยะเวลาการขาย : จนกว่าของจะหมด